Primera Technology DP-XRn - Manual (Page 10)

6 Hardware and Software Setup
Section 2: Hardware and Software
Setup
Setup
This section will describe the step-by-step process of setting
up your unit. This includes information on how to load the
supplies (ink and disc media) necessary to start producing
discs.
A. HARDWARE SETUP
Step 1: Applying Power
• Locate the power cord supplied with the unit.
• Place one end of the power cord into the plug on the back
of the unit and
the other end
into a surge
protected
outlet.
• Turn on the
power switch
located on the
back of the
unit above
the fan.
• Unit will initialize for approximately 60 seconds.
Step 2: Installing Ink Cartridges
• Using the LCD Control Panel access the Main Menu of the
XRn by pressing the button.
Choose "Install Cartridges"
• Using the key provided, open the front
cover of the unit. The cartridge carrier
will move to the
load position.
• Open the ink cartridge covers.
• Remove the ink cartridge from its
packaging.
• Slowly remove the tape covering the cartridge's print head,
being careful to avoid damaging the barcode label on the
underside of the cartridge.
Power Switch