Roller cleaning paper, Er to – Panasonic KV-S2065L User Manual

Page 40

Advertising
background image

40

Cleaning the Unit

¥

Re-attachment of the sensor roller

When the sensor roller is removed while cleaning the inside of the scanner, re-attach it as shown below.

Lower sensor roller:
Attach the roller by placing the gear side to
the left side of the scanner and inserting
both side’s bearings into the guide grooves.
•

After attaching, press down on top of the sensor
roller with your finger to confirm if it moves or
not.

Upper sensor roller:

1

Attach the roller by inserting the bearing
of the gear side of the roller into the guide
groove on the left side of the scanner.

•

Match the flat side of the bearing with the
flat side of the guide groove.

2

Hold the shaft on the right side of the
sensor roller, push the tip of the gear, and
slide the sensor roller in the direction of
the arrow

Œ

.

Then attach the roller by inserting the
bearing of the non-gear side of the roller
into the guide groove on the right side of
the scanner.

•

Match the flat side of the bearing with the
flat side of the guide groove.

∫

∫

∫

∫

Roller cleaning paper

Open the bag on the dotted line and take out
the roller cleaning paper.
•

If the bag is left open for a long period of time,
the alcohol will evaporate.
Please use the roller cleaning paper
immediately after opening the bag.

§

The roller cleaning paper (Model No. KV-SS03) is available from the dealer where you
purchased your scanner.
For supplies and accessories: Call 1-800-346-4768 (U. S. A. only) or your dealer.

Gear

Bearing

Sensor roller

Guide groove

Please attach the right side bearing in the same way.

Gear

Bearing

Sensor roller

Guide groove

1

2

Dotted line

Advertising
This manual is related to the following products: