Palsonic DVD3000 - Manual (Page 13)

l
Remote control preparation
Use batteries size #7
Battery installation:
Insert the batteries while observing the correct
Notes:
(+) and (-) polarities as illustrated below.
Service life of batteries:
The batteries depend on how
often and for what operations the
remote control unit is used.
l If the remote control unit fails
to work even when it is operated
near the player, replace the
batteries.
Notes:
Do not use rechargeable (Ni-
Cd ) batteries.
Do not attempt to recharge or
short-circuit the batteries.
Do not drop, step on or impact
the remote control unit. Otherwise
this may damage the parts or lead
to malfunction.
Do not point bright lights at the remote control
signal sensor.
Do not place objects between the remote control
unit and the remote control signal sensor.
Do not use this remote control unit while
simultaneously operating the remote control unit of
any other equipment.
DVD play
l Do not mix old and new batteries.
If the remote control unit is not going to be used for
Preparation:
l Switch on the TV set’s power and select “AV” as
a long time, remove the batteries. Otherwise,
AMPLIFIER CENTER AUDIO
FRONT AUDIO(L) FRONT AUDIO(R)
SURROUND AUDIO(L) SURROUND AUDIO(R)
SUBWOOFER AUDIO
electrolyte may leak which may lead not only to
malfunctioning but also to rust if contacting with
the electrolyte.
l Wipe away any electrolyte leaking inside the
remote control unit, and install new batteries.
l If any electrolyte should come into contact
with parts of your skin, wash it off thoroughly
with water.
Remote control unit operating range
Point the remote control unit no more than 7m
from the remote control sensor and about 60 of
the front of the unit.
11
C
l
l
l
l
l
l
l
l
l
l