ParaBody 888 - Manual (Page 9)

9
STEP 5:
FIGURE 5
• CAREFULLY slide one GUIDE ROD (9) through the upper hole in the UPRIGHT FRAME (8 &22). Slide one 1” SHAFT
COLLAR (11) over the bottom of the GUIDE ROD (9), CAREFULLY lower the GUIDE ROD (9) through the HOUSING (6) on
the SMITH BAR (5) and into the bottom hole of the UPRIGHT FRAME (8 & 22). Repeat this step on the other side.
10
5
6
11
9
8
• Slide the 1” SHAFT COLLARS (11) up the GUIDE RODS (9) to the bushing and SECURELY TIGHTEN.
• Hook the SMITH BAR (5) into the slots of the UPRIGHT FRAMES ( 8).
22