Panasonic KX-TG9391 - Manual (Page 31)

Programming
31 For assistance, please visit http://www.panasonic.com/help
Special instructions for
programmable settings
Night mode
Night mode allows you to select a span of time
during which the unit will not ring for outside calls.
This feature is useful for those occasions when
you do not want to be disturbed, for example, while
sleeping. Night mode can be set independently for
each base unit and handset.
Important:
L Set the date and time beforehand (page 17).
L If you have set the alarm, the alarm sounds even
if the night mode is turned on.
Setting the start and end time
1 { MENU} i {#}{2}{3}{7}
2 Enter the desired hour and minute you wish to
start this feature.
3 Press {*} to select “AM” or “PM”. i {OK}
4 Enter the desired hour and minute you wish to
end this feature.
5 Press {*} to select “AM” or “PM”. i {OK}
6 Proceed with the operation for your unit.
Base unit: {
■} (EXIT)
Handset: {OFF}
Note:
L To correct a digit:
Base unit: Press {7} or {8} to move the
cursor to the digit, then make the correction.
Handset: Press {<} or {>} to move the cursor
to the digit, then make the correction.
Turning night mode on/off
1 { MENU} i {#}{2}{3}{8}
2 {V} /{^}: Select “On” or “Off”. i {SAVE}
3 Proceed with the operation for your unit.
Base unit: {
■} (EXIT)
Handset: {OFF}
Note:
L When the night mode is turned on, 3 is
displayed.
Alarm
An alarm sounds at the set time for 3 minutes once
or daily. Alarm can be set for each handset.
Important:
L Set the date and time beforehand (page 17).
1 { MENU} i {#}{7}{2}{0}
2 {V} /{^}: Select the desired alarm option. i
{ SELECT}
3 Set the desired time. i {OK}
4 {V} /{^}: Select the desired ringer tone. i
{ SELECT}
L We recommend selecting a ringer tone
different from the ringer tone set for outside
calls.
5 {V} /{^}: “Save” i {SELECT} i {OFF}
L When the alarm is set, E is displayed.
Note:
L To stop the alarm, press any dial key or place
the handset on the charger.
L When the handset is in use, the alarm will not
sound until the handset is in standby mode.
L If you select “Once”, the setting changes to
“Off” after the alarm sounds.
L The ringer volume for alarm follows the higher
volume level of the 2 lines (page 29).
L When the ringer volume for outside calls of the 2
lines is set to off (page 29), the alarm sound is
heard at a low level.
Customer support
The base unit and handset can display the Internet
address where you can download the operating
instructions or get further information for this
product by using your computer.
1 { MENU} i {#}{6}{8}{0}
: Base unit / Y Handset
: Base unit / Y Handset
Y Handset
Off Turns alarm off. Go to step 5.
Once An alarm sounds once at the set
time. Enter the desired month,
date, and year.
Daily An alarm sounds daily at the set
time.
: Base unit / Y Handset
TG9391.book Page 31 Tuesday, July 8, 2008 8:01 AM