Promise Technology FastTrak TX4000 - Manual (Page 15)

Chapter 2: Quick Start
11
Creating a Security Array with New Drives
Notes
Under the Security setting, FastTrak TX4000 permits two
drives to be used for a single Mirrored array or four drives to
be used for a Mirrored/Striped array in Auto Setup.
When creating a Security array with new drives, a feature
called Gigabyte Boundary will automatically be set to ON.
For a description of the Gigabyte Boundary feature, see
page 23.
To create an array for data protection using new hard drives, follow these steps:
1. Using the Spacebar, choose Security under the Optimize Array for section.
2. Press Ctrl-Y to Save your selection.
3. The window below will appear.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
4. Press N for the Create Only option.
5. A window will appear almost immediately confirming that your Security array
has been created. Press any key to reboot the system.
Array has been created.
<Press Any Key to Reboot>
6. Proceed with normal FDISK and format procedures as if you had just
installed a new hard drive.
7. Once the arrayed drives have been formatted, proceed to Chapter 4 to
install your operating system and/or FastTrak TX4000 driver.