Porter-Cable 28-475X - Manual (Page 18)

18
TILTING THE TABLE
1. The table on the band saw can be tilted 45 degrees
to the right and 8 degrees to the left. To tilt the table to
the right, loosen the two clamp handles (A) Fig. 43, tilt
the table to the desired angle as shown on the scale (D)
Figs. 43 and 44, and tighten two locking handles (A) Fig.
43.
Fig. 43
2. To tilt the table to the left, loosen the two locking
handles (A) Fig. 43, and tilt the table to the right until the
table stops (B) Fig. 44 can be accessed. Rotate the table
stop (B) Fig. 44, and tilt the table to the left. Tighten the
two locking handles (A) Fig. 43.
Fig. 44
ADJUSTING THE
TABLE STOPS
1. Loosen the table clamp handles (A) Fig. 43, and tilt
the table to the right.
2. Rotate the stop (B) Fig. 45 out of the way.
3. Place a square (G) Fig. 46, on the table and set
blade square to table.
4. Clamp table handles (A) Fig. 43.
5. Rotate the stop (B) Fig. 45, until the tallest screw is
under the table skirt.
6. Turn the screw up or down until the screw touches
the table skirt.
7. Set pointer (J) Fig. 47 to “0” by loosening screw (K)
Fig. 47, and move pointer (J) to the “0” degree mark, and
tighten screw (K).
To adjust the 90 degree stop
Fig. 45
Fig. 46
DISCONNECT MACHINE FROM POWER
SOURCE.
DISCONNECT MACHINE FROM POWER
SOURCE.
A
A
B
B
F
G
D
D