Philips Clon99-BKI - Manual (Page 10)

10
SMART
PLUG
75 Ω
ANT/
CABLE
EXTERNAL
SPEAKER
PHILIPS
SMARTLOADER 99
Copyright PCEC 1999
System Version D.0
PN 3135 019 01681
PRESS POWER TO BEGIN
Philips SmartLoader 99
System Version D.0
Press CH/UP to Write TV
Press Power to Exit System
Stored Memory Type 01, 04
Philips SmartLoader 99
System Version D.0
Press CH/UP to Confirm Write
Press CH/DN to Abort
Press Power to Exit System
Stored Memeory Type 01, 04
Philips SmartLoader 99
System Version D.0
Writing Block 23 of 63
Philips SmartLoader 99
System Version D.0
6 STEREO
INSTALL / MENU
– VOLUME + CHANNEL
POWER
MENU
– VOLUME + CHANNEL
POWER
4
5
6
8
3
2
1
Press CH/UP to Confirm Write
Press CH/DN to Abort
Press Power to Exit System
Finished Writing Memory
Press CH/UP to Confirm Write
Press CH/DN to Abort
Press Power to Exit System
P
ROGRAMMING
A T
ELEVISION
W
ITH
T
HE
O
N
-S
ET
K
EYBOARD
W RITING TV M EMORY
WITH THE O N -S ET K EYBOARD
After the Memory has been read from
one television, the Clon99-BK
SmartLoader is now ready to write
the memory to other televisions. The
following steps show how to down-
load or “write” memory from one
television to another using the On-Set
Keyboard.
Plug one end of the cable into the
jack provided on the SmartLoader.
Then plug the other end into the jack
provided on the back of the TV. The
TV jack is next to the Antenna Input
terminal.
Push the Slide Switch to the ON
position on the SmartLoader. If the
TV is currently off, it should turn on
within 15 seconds.
Within 20 seconds, the
SmartLoader on-screen display
should appear on the TV screen. If
the display does not appear, check
connections and push the Slide
Switch to the ON position again. If
there is still no response from the
SmartLoader, replace its 9-volt bat-
tery.
Press the POWER button on the
front of the TV to display the
Clon99-BK SmartLoader “Write TV”
Menu.
Press the CH/UP button on the
front of the TV to write the memory
to the television.
The screen will ask “Press
CH/UP to Confirm Write,” “Press
the CH/DN to Abort,” or “Press the
Power to Exit System.” Press the
CH/UP button to confirm and begin
the procedure.
The screen will indicate “Writing
Block XX of XX” while the Clon99-
BK SmartLoader is downloading the
data.
The display will then read “Finished
Writing Memory” when the proce-
dure has been completed.
Press the Power button on the
front of the TV to EXIT the system.
BEGIN
Typical rear jack
panel of ITV
Clon99-BK SmartLoader Box
ON/OFF Slide Switch
LED