Precor Leg Press S3.25 - Manual (Page 5)

S3.25 Leg Press Option Assembly Instructions
page 5
2
Preparations
Preparations
CAUTION: To set up this equipment, you will need
assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this
guide. If you do not assemble and use the Leg Press
Option according to the following guidelines, you could
void the Precor limited warranty.
Required Tools
You need to obtain these tools before assembling
the unit:
❑ ¾-inch socket wrench
❑ ¾-inch box-end wrench
❑ ⁹⁄₁₆-inch socket wrench
❑ ⁹⁄₁₆-inch box-end wrench
❑ Two adjustable pliers or crescent wrenches
❑ Standard set of metric Allen wrenches
❑ Utility knife or scissors
❑ Measuring tape
Installation Requirements
Follow these installation requirements when
assembling the unit:
• Fill out and mail the limited warranty card.
The warranty card is found on the back cover of
this guide.
• Set up the Leg Press Option on a solid, flat
surface. A smooth, flat surface under the unit helps
keep it level. A level unit has fewer malfunctions.
• Provide ample space around the machine.
Open space around the machine allows for easier
access.
• Insert all bolts in the same direction. For
aesthetic purposes, insert all the bolts in the same
direction unless specified (in text or illustrations) to
do otherwise.
• Leave room for adjustments. Tighten fasteners
such as bolts, nuts, and screws, so that the unit is
stable, but leave room for adjustments. Do not fully
tighten fasteners until instructed in the assembly
steps to do so.
Assembly Tips
• A 6-inch scale is provided at the bottom of every
assembly instruction page. Use this scale to identify
the correct size bolts and spacers. The head of a
bolt is not used in measuring the length of a bolt.
To find out the length of a particular bolt, measure its
shank (the long, narrow part beneath the head). Refer
to the following diagram.
• Read all caution notes on each page before
completing that step.
• Some pieces have extra holes that you will not use.
Use only those holes indicated in the instructions
and illustrations.
• While you may be able to assemble the Leg Press
Option by using the illustrations only, refer to the
text for important safety cautions and notes.
Bolt head
Bolt threads
Shank
To determine the
length of a bolt,
measure its shank.