Pride Mobility Hurricane PMV User Manual
Page 35
35
Hurricane
www.pridemobility.com
I X . D I S A S S E M B L Y A N D A S S E M B L Y
Toggle Latch Release
1. Push in the toggle latch release
button while pulling back the
toggle latch. See figures 16 and
18A.
2. Position the toggle latch buckle
over the top of the toggle latch.
See figure 18B.
TOGGLE
LATCH
TOGGLE LATCH
RELEASE
BUTTON
Figure 18. Toggle
Latch (Latched)
Figure 18B. Buckle
Secured
ASSEMBLY
1. Position the front and rear sections of your PMV as shown in figure 21.
2. Align the lower slots of the front section with the corresponding pegs on the front of the rear section. See figure 21.
3. Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 19.
4. Raise the tiller.
WARNING! Position the front-to-rear harness so it won’t become pinched between the
frame halves when pivoting the rear section forward. See figure 21.
Figure 21. Frame Sections
Frame Separation
1. Lower the tiller to the PMV
floorboard.
2. Push back on the seat post to
pivot the PMV’s rear section
rearwards until the rear section
is standing vertically on its
bumper. See figure 19.
3. Lift the front section up until the
lower pegs are no longer in the
slots. See figure 20.
4. Carefully move the front sec-
tion away from the rear section.
Figure 19. Frame Positioning
Figure 20. Separating The
Frame Sections
FRONT-TO-REAR HARNESS
5. Latch the toggle latch. See figure 18A.
Lower the toggle latch buckle.
Push back on the toggle latch so it locks into place.
6. Reinstall the batteries into the battery wells and reconnect the
battery strap.
7. Connect the front-to-rear harness and both T-handle battery
harnesses.
8. Reinstall the shroud.
9. Reinstall the seat, and lock it into place.
Figure 18A. Toggle
Latch (Unlatched)
TOGGLE LATCH
BUCKLE
CURVED LOCKING
BRACKET
PEG
PEG
SLOT