Panasonic KX-HCM230 - Manual (Page 5)

5
Network Camera Cabling
1.
2.
Put the cables through the Connector Cover (1.). Connect the DC plug of the AC adaptor to the DC IN
jack (2.) and Category 5 straight/cross cable to the Ethernet port (3.). Attach the AC cord to the AC
adaptor (4.). Connect the AC plug to the power outlet (5.).
Thread the AC adaptor cord through the hook. Put the Rubber Cap and the Connector Cover by fastening
the three screws in numerical orders. A remaining screw hole of Connector Cover is used for attaching
Sunshade.
Please check the location where Network Camera should be installed. Select the proper cable fitted to the
Network Camera location.
Notes
External I/O and Ground should be
threaded through Connector Cover.
Once you putty the cables, External
I/O and Ground cannot be connected
till you take the putty off.
Note
Be sure to thread the AC adaptor cord
through the hook.
Please check the location of Network
Camera, the type and the length of
the Ethernet cable (Max. 100 m).
Please use the Ethernet cable as
short as possible for outdoor.
Lightning may cause serious damage
to the Network Camera.
Use Category 5 cross cable when
connecting directly to the PC.
Connector Cover
Hook
AC
adaptor
cord
1
2
3
Carefully insert the
Rubber Cap into the
hole, gently pressing
it into place using
the end of the
long tool.
To Network
DC IN
jack
Ethernet
port
DC Plug
Connector
Cover
(3.)
(2.)
(1.)
(5.)
(4.)
Category 5 straight/cross cable
Power
Outlet
AC adaptor
AC plug
AC cord
PSQX2811XB.book 5 ページ ２００３年５月３０日 金曜日 午後４時３８分