Philips MCM196D - Manual (Page 15)

15
English
Adjusting volume and sound
1
Turn the VOLUME control anti-clockwise to
decrease or clockwise to increase volume on the
system (or press VOL
-/+ on the remote
control).
➜
Display shows the volume level
VOL and a
number from 0-32.
2
Press DSC repeatedly to select the desired
sound effect: JAZZ / POP / CLASSIC / ROCK.
3
Press DBB to switch bass enhancement on or
off.
➜
Display shows: if the DBB is activated.
4
Press MUTE on the remote
control to interrupt sound
reproduction instantly.
➜
Playback will continue
without sound.
● To activate sound
reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY ON or SOURCE (or 2on
the remote control).
➜ The system will switch to the last selected
source.
●
Press CD, iPod, TUNER, TAPE or AUX on
the remote control.
➜
The system will switch to the selected source.
To switch the system to standby mode
●
Press STANDBY ON on the system (or 2on
the remote control).
●
If in tape mode or recording mode, press
STOP•OPEN Ç0 first.
➜
The volume level (up to a maximum volume
level of 12), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
To switch the system to Eco-power
standby mode
● Press and hold STANDBY ON (y on the
remote control) for more than 2 seconds.
➜ The display will go blank.
Power-saving automatic standby
The power-saving feature automatically switches
to Eco power standby 15 minutes after a CD
playback has ended and no control is operated.
M I C R O S Y S T E M M C M 1 9 6 D
PG001-027 MCM196D_37_IFU_Eng 14/5/07, 13:20 15