Philips 7349XL - Manual (Page 9)

ENGLISH 16
C
6 Open Razor Head assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue. This could damage the
shaving heads.
C
7 If the shaving unit becomes detached from
the razor, you can easily reattach it.
8 You may also clean the hair chamber
without water by using the supplied brush.
Once A Month: Razor Heads
Do not mix up the cutters and combs as the
shaving performance may be adversely affected for
several weeks before optimal shaving performance
is restored.
1 Turn razor OFF, remove the charging plug
from the outlet and cord from the razor.
C
2 Press the razor head release button to
open the razor head assembly.
C
3 Turn the black 3-pronged locking bracket
counterclockwise (1) and remove the
retaining frame (2).
ENGLISH 17
C
4 Remove and clean one set of cutters and
combs at a time.
C
5 Separate the cutter from the comb and
rinse clean under hot water.
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C
6 Replace the set back into the Razor Head
Assembly so that the “wings” on the comb
fit within the brackets located towards the
center of the Assembly.
The set will only fit into the Razor Head Assembly
if the ‘wings’ are between the brackets. Make sure
that the two pointy edges of the head fit exactly
into the recesses.
7 Repeat the process for the other two sets
of cutters and combs.
8 Replace the frame.
C
9 Press down (1) and turn the black
3-pronged locking bracket clockwise (2)
until it locks into place.
16