Precor EXPERIENCE STRENGTHTM C-LINE CW34871-101 - Manual (Page 33)

Attach the Bottle Holder/Accessory Tray
To Attach the Bottle Holder/Accessory Tray to the
Weight Tower Frame:
1. Locate the bottle holder/accessory tray. Snap the two pieces
together and set them aside.
Note: For this unit, the bottle holder/accessory tray attaches to the
side of the front weight tower upright.
2. Place the bottle holder bracket upside down (curved side at the top)
and attach it to the weight stack tower using:
Two custom bolts
Two lock washers
Two flat washers
Two ³ ₈” - 16 low head bolts
One ³ ₁₆” hex key
One 1" open-ended wrench
Note: The custom bolts pass through the frame from the inside hole
and align with the smaller hole on the outside of the frame.
Figure 6: Bottle holder bracket attachment
3. Set the bottle holder/accessory tray on top of the bottle holder
bracket and align it with the bracket screw holes. Attach it to the
bracket using:
Two #8 - 32 machine screws
Note: Attach screws firmly, but do not overtighten.
Figure 7: Bottle holder/accessory tray attachment
Abdominal Assembly and Delivery Guide: Attach the Bottle Holder/Accessory Tray 6