Porter-Cable 698 - Manual (Page 4)

4
13. DON T OVERREACH. Keep proper footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better
and safer performance. Follow instructions for lubricating and changing
accessories. Inspect tool cords periodically and if damaged, have repaired by
authorized service facility. Inspect extension cords periodically and replace if
damaged. Have all worn, broken or lost parts replaced immediately. Keep
handles dry, clean and free from oil and grease.
15. DISCONNECT TOOLS when not in use, before servicing, and when
changing accessories such as blades, bits, cutters, etc.
16. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking
to see that keys and adjusting wrenches are removed from the tool before
turning it on.
17. AVOID UNINTENTIONAL STARTING. Do not carry a plugged-in tool
with finger on switch. Be sure switch is off when plugging in. Keep hands,
body and clothing clear of blades, bits, cutters, etc. when plugging in the tool.
18. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use
only extension cords marked Suitable for use with outdoor appliances store
indoors when not in use.
19. STAY ALERT. Watch what you are doing. Use common sense. Do not
operate tool when you are tired or while under the influence of medication,
alcohol or drugs.
20. USE RECOMMENDED ACCESSORIES. Consult the owner s manual for
recommended accessories. The use of improper accessories may cause risk
of injury to persons.
21. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped
or if the cutting tool is unintentionally contacted.
22. CHECK DAMAGED PARTS. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
23. DIRECTION OF FEED. Feed work into a blade or cutter against the
direction of rotation of the blade or cutter only.
24. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don t leave tool until it comes to a complete stop.
25. WEAR EAR PROTECTION to safeguard against possible hearing loss.
SAVE THESE INSTRUCTIONS
ADDITIONAL SAFETY RULES FOR ROUTER/SHAPER
1. DO NOT USE awkward hand positions.
2. K E E P F I N G E R S A W A Y from revolving cutter use fixtures when
necessary.
3. USE CUTTER GUARDS for all applications.
4. KEEP CUTTER GUARDS IN PLACE and in working order.
5. KEEP CUTTERS SHARP.