Pioneer SH-DT510 - Manual (Page 9)

9
Chapter 2: Installation
Introduction
If your service provider or system installer has already set up the antenna and
connected the tuner, then you can start the operations specified in Chapter 4.
However, if you are setting up the system by yourself, please read through this
section and be sure you follow all of the precautions listed under "Safety First".
Package Contents
Unpack the tuner and check that all of the items listed below are included.
• SH-DT510 Digital High Definition tuner
• Remote Control Unit (with 2 AAA batteries)
• Audio Cable
• Video Cable
• Y/Pb/Pr cable
• Power Cable
• Operating instructions
Description of Equipment
The SH-DT510 digital High Definition tuner is designed to receive Free-To-Air
digital programming from VHF/UHF terrestrial TV channels. Please see the following
description:
Remote Control Unit (RCU)
The RCU provides easy access to all of the tuner's functions, including selecting
channels and using the menus. It uses infrared signals and must be operated at a
distance of three to four meters from the receiver. When using the RCU, be sure that
there is a direct line of sight to the tuner.
The batteries for the RCU are packaged separately. Before
you start using the tuner, please install these batteries with
+/- terminals aligned as per the picture below.
Note:
• To avoid damaging the RCU through battery leakage,
discard any depleted or old batteries.
• When disposing of used batteries, please comply
with governmental regulations or environmental public
instruction's rules that apply in your country/area.
1
2