Panasonic DP-6010 - Manual (Page 20)

Basic Transmission Settings
20
The Original setting is useful when sending photographs or illustrations with gray tones. Your machine is
preset to "TEXT". You can select either "TEXT/PHOTO" or "PHOTO" mode.
NOTE 1. When you select TEXT/PHOTO, or PHOTO, you machine will automatically select Fine
Resolution.
2. When you store a document in memory, the Verification Stamp will stamp on the document if it
is successfully stored in memory. In this case the Verification Stamp is not a confirmation that
the document was successfully transmitted. If you wish to disable the use of the Verification
Stamp when storing document in memory, change the setting of Fax Parameter No. 28. (See
page 189)
3. To change the preset Verification Stamp position, change the setting of Fax Parameter No. 04.
(See page 188)
Original (Text/Photo)
Others
Sending 2-Sided Original(s)
2-Sided scanning selection control is available for the user depending on the original layout. The
following selections are available for the 2-Sided scanning option:
• Long Edge : 2-Sided scanning aligned to the long edge of the original.
• Short Edge: 2-Sided scanning aligned to the short edge of the original.
Verification Stamp
• Confirms successful transmissions by stamping the bottom of each successfully transmitted
page with a small mark.
You or a selected party can be notified with a Job Completion Notice via a pop up screen on your/
their PC when the Copy Job or the Print Job is completed. You must setup the Job Completion
Notice feature prior to starting the job and properly setup the Status Monitor.
Confirms the commication status.
Retrieving the Email temporarily.
TEXT
TEXT/PHOTO
PHOTO
for text only originals
for text and photo originals
for photo or illustration originals
2-SIDED
ORIGINAL
X-STAMP
COMPLETION
NOTICE
COMM. STATUS
GET EMAIL