Panasonic KX-TG6502 - Manual (Page 26)

Programmable Settings
26
Ringer Tone
You can set the handset and base unit ringers to use one of 8 ringer patterns for
each line. “Tone 1” to “Tone 4” are bell ringer patterns. “Melody 1” to “Melody 4” are
melody patterns. LINE 1 is preset to “Tone 1”. LINE 2 is preset to “Tone 2”.
• You cannot change the ringer tone for intercom calls.
• If you subscribe to a Distinctive Ring Service (such as IDENTA-RING) from your
telephone company with 2 or 3 consecutive rings, select a bell ringer pattern (Tone
1 to 4). If you select a melody pattern, you will not be able to distinguish lines by
their ringers.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person answers the call using another phone connected on the same line.
• If LINE 1 and LINE 2 have different ringer patterns and both lines receive calls
simultaneously, both ringers will ring alternately.
Handset ringer tone
1 Press [MENU].
2 Scroll to “Ringer setting” by pressing
[d] or [B], then press the soft key ( ).
3 Scroll to “Ringer tone” by pressing [d] or
[B], then press the soft key (
).
4 Press [d] (Line1) or [B] (Line2) to select
the line.
5 Select the desired ringer tone by pressing
[d] or [B].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring.
• You can also select the ringer tone by pressing [1] to [8].
[1] to [4]: Bell ringer patterns
[5] to [8]: Melody patterns
To adjust the ringer volume, press the soft key ( ). Adjust the
ringer volume by pressing [d] or [B]. See “Handset ringer volume”
on page 24, step 5.
6 Press the soft key ( ).
• To select the other line, repeat from step 3.
7 Press [OFF].
Handset
SELECT
Ringer setting
SELECT
Ringer tone
Ringer tone
d
=Line1
B
=Line2
Ringer tone L1
1:Tone 1
dB
BACK VOLUME SAVE
VOLUME
SAVE
TG6500.book Page 26 Friday, June 25, 2004 6:56 PM