Pioneer DEH-P65BT - Manual (Page 43)

Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Use MULTI-CONTROL to select
WARNING.
2 Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 46.
1 Use MULTI-CONTROL to select AUX1/
AUX2.
2 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP:FULL) or subwoofer
( REAR SP:SUB W) connection. If you switch
the rear output setting to REAR SP:SUB W,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP:FULL). When rear out-
put is connected to full range speakers (when
REAR SP:FULL is selected), you can connect
other full range speakers (
PREOUT:FULL) or a
subwoofer ( PREOUT:SUB W) to the RCA rear
output.
1 Use MULTI-CONTROL to select REAR SP.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween REAR SP:FULL (full-range speaker) and
REAR SP:SUB W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select
REAR SP:FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP:SUB W.
# When the rear output setting is
REAR SP:SUB W, you cannot operate the follow-
ing procedure.
3 Push MULTI-CONTROL left or right to
switch the subwoofer output or rear out-
put.
Pushing
MULTI-CONTROL left or right will
switch between PREOUT:SUB W and
PREOUT:FULL and that status will be dis-
played.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
39).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use MULTI-CONTROL to select TEL.
Operating this unit
En
43
English
Section
02