Pioneer DVR-440H-S - Manual (Page 127)

The Initial Setup menu 14
127
En
Additional information about the
TV system settings
About the input line system
This recorder is compatible with PAL,
SECAM, 3.58 NTSC and PAL-60 TV systems.
The Input Line System and Input Colour
System settings determine how the recorder
treats incoming video signals from an
external input or the built-in TV tuner.
Please note the following points when
changing the input line system:
• When the current input is a built-in tuner
channel preset, changing the input line
system will usually also affect the input
line system of the
AV2 (INPUT 1/
DECODER) input. However if the AV2/L1
In setting is set to Decoder , then the L2
input is affected instead.
• If, when the Input Line System setting is
changed, the screen goes blank (due to
incompatibility with your TV), you can
switch back by pressing and holding the
front panel
STOP button then pressing
OPEN/CLOSE (also front panel) while
the recorder is stopped.
• When you switch the Input Line System
setting the Copy List is erased. If you
switch the setting using the
STOP
button and OPEN/CLOSE buttons as
described above, there is no
confirmation, so please use with care.
• You can’t mix recordings of different TV
line systems on the same disc.
• When you change this setting, the Input
Colour System setting also changes
(see below).
About NTSC on PAL TV
Depending on the Input Line System setting
and the NTSC on PAL TV setting, the signal
format output when the recorder is stopped
varies as shown in the table below.
Set Preview
(HDD only)
Quick Preview • When in the Disc Navigator, the thumbnail video
plays short excerpts from throughout the selected
title. (Note that edited titles that will play normally
from the beginning.)
Normal The thumbnail video plays from the beginning of the
title.
Setting Options Explanation
Input Line
System NTSC on PAL
TV
Output
when
stopped
625 System Off PAL
On PAL
525 System Off NTSC
On PAL–60
DVR540H_WV_EN.book 127 ページ ２００６年２月１６日 木曜日 午後４時３４分