Panasonic KX-CL510 - Manual (Page 3)

For Your Safety
3
Warning
To prevent fire or shock hazard, do not expose this
product to rain or any type of moisture.
Caution
• Do not open covers and do not attempt to repair the unit
yourself. Refer servicing to qualified personnel.
• This product uses low frequency electromagnetic fields
and may cause harmful interference to sensitive
medical implant devices. If you have a cardiac
pacemaker or implantable defibrillator, please consult
your doctor for additional suggestion or advice.
Warning
• The power source voltage of this unit is listed on the
nameplate. Only plug the unit into an outlet with the
proper voltage.
• When you operate this equipment, the outlet should be
near the equipment and accessible.
• To ensure safe operation the AC cord supplied must be
inserted into standard three-prong AC outlet which is
effectively grounded (earthed) through the normal
wiring.
• The fact that the equipment operates satisfactorily does
not imply that the power point is grounded (earthed) and
that the installation is completely safe. For your safety, if
in any doubt about the effective grounding (earthing) of
the power point, consult a qualified electrician.
• If the plug cannot be inserted into the AC outlet, contact
a licensed electrician to replace the outlet with a
properly grounded (earthed) one.
• Do not defeat the purpose of the grounding (earthing)
plug (ex. do not use a conversion plug).
• (220-240 V equipment)
A certified power supply cord has to be used with this
equipment. The relevant national installation and/or
equipment regulations shall be considered. A certified
power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227
(designation H05VV-F 3G 1.0 mm
2 ).
Caution
This printer utilizes a laser. Use of controls or adjustments
or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Warning
Make sure that the printer is installed in a well ventilated
room so as not to increase density of ozone in the air.
Since ozone is heavier than air, it is recommended that air
at floor level be ventilated.
The printer weighs approximately 30 kg (66 lbs.). It must
be handled by two people. Turn the power off and remove
the power cord when handling the unit.
Warning
Do not incinerate toner or toner containers. Toner dust
may cause flashback when exposed to an open flame.
General
Power Source
Laser Safety
CLASS 1 LASER PRODUCT
Laser diode properties (4 provided)
Laser output
: 5 mW max
Wavelength : 785 nm
Emission duration : Continuous
Ozone Release
Moving the Unit
Waste Disposal
For Your Safety
For Your
S
a
fety
For Your
S
a
fety