ProForm PFEL73207.0 - Manual (Page 10)

10
9. The Console (10) can be operated with four
“D” batteries (not included); alkaline batteries
are recommended. IMPORTANT: If the ellip-
tical exerciser has been exposed to cold
temperatures, allow it to warm to room
temperature before inserting batteries into
the Console. If you do not do this, the con-
sole displays or other electronic compo-
nents may become damaged. Remove the
battery cover from the back of the Console
and insert four batteries into the battery com-
partment. Make sure that the batteries are
oriented as shown by the diagram inside
the battery compartment. Then, reattach the
battery cover.
Note: The Console (10) can be also be oper-
ated with an optional power supply instead of
batteries. To purchase a power supply, call
the telephone number on the front cover
of this manual. Plug one end of the power
supply into the jack on the console. Plug the
other end of the power supply into an appro-
priate outlet that is properly installed in accor-
dance with all local codes and ordinances.
10. Have a second person hold the Console (10)
near the Upright (2) as shown. Connect the
console wire to the Upper Wire Harness (18).
Attach the Console (10) to the Upright (2)
with four M4 x 16mm Screws (60). Be careful
to avoid pinching the wires.
2
Console Wire
18
60
10
Batteries
Battery
Cover
10
Avoid pinching the
wires during this step
9
10