Panasonic SJ-MR270 - Manual (Page 37)

RQT7177
37
English
c
ontrol
guide
Power Supply
Refer to the illustrations on page 7.
The rechargeable battery
1 Put the battery into the unit.
2 Install the unit to the multi cradle/
battery charger, and connect the
AC adaptor to the multi cradle/bat-
tery charger.
Recharging begins.
“CHARGE” appears on the display while
recharging and “CHARGE” disappears
when the battery is fully charged. It takes
approximately 3.5 hours to recharge the
supplied battery.
Insert an MD
Refer to the illustration on page 8.
1 Slide [OPEN 1] in the direction of
the arrow to open the lid.
2 Slide the MD between the guides
so it clicks into place.
3 Now close the lid.
Slide [OPEN 1] in the direction of the
arrow to remove the disc. The disc
springs out from the unit.
Refer to the illustrations on pages 9 to
10.
Preparation Preparation
≥ Release HOLD.
≥ Connect this unit to a unit that has a
digital output terminal or stereo LINE
OUT terminals, or the microphone.
≥ Insert the rechargeable battery into the
unit.
≥ Insert a recordable MD.
1 Slide [REC ➞, LP MODE] (main
unit) to the right or press and hold
[T.MARK/EQ, %REC] (remote con-
trol) until the display changes.
The unit comes on and enters the
recording standby mode.
2 Slide again [REC ➞, LP MODE]
(main unit) to select the recording
mode.
The mode changes each time you do this.
LP2 (X 2)
( ------------------------------------]
; |
LP4 (X 4) |
; |
No display (Normal stereo recording) --}
3 1 Press [1 ;] (main unit) or
[PLAY MODE, REC PAUSE]
(remote control) to start record-
ing.
2 Begin playback of the source or
face the microphone towards
the source of the sound.
∫ To stop recording
Press [1 ∫] (remote control) or
[∫, OPR OFF/%HOLD] (main unit).
≥ The unit powers itself off automatically
in about a minute.
≥ You can even turn off the unit by press-
ing again [∫, OPR OFF %HOLD]
(main unit) while stopped.
Recording
The HOLD Function
Main unit
Preparation : After pressing [1 ;],
press [∫, OPR OFF % HOLD].
Press and hold [∫, OPR OFF/%HOLD]
until “HOLD ON” displays.
∫ To release
Preparation : Press [1 ;].
“HOLD” is displayed.
Press and hold [∫, OPR OFF/%HOLD]
until “HOLD OFF” displays.
Remote control
Refer to the illustration on page 8.
Playback
Refer to the illustrations on page 13.
Preparation Preparation
≥ Release HOLD.
≥ Insert an MD.
≥ Connect the remote control and stereo
earphones, then insert the remote con-
trol’s plug into the earphone jack [Ë]
on the unit.
∫ To listen through the speakers
1. Insert a rechargeable battery into the
unit.
2. Install the unit to the multi cradle.
3. Connect the AC adaptor to the multi
cradle.
4. Connect the speakers to the multi cra-
dle.
1 Press [1/∫] (remote control) or
[1 ;] (main unit) to start play.
2 Move [1/∫] (remote control) toward
[r] or [s], or [1 ;] (main unit) up
or down to adjust the volume.
∫ To stop playback
Press [1 ∫] (remote control) or
[∫, OPR OFF/%HOLD] (main unit).
≥ The unit powers itself off automatically
in about a minute.
≥ You can even turn off the unit by press-
ing again [∫, OPR OFF %HOLD]
(main unit) while stopped.
SJ-MR270
Editing MDs
DIVIDE (Dividing a track into two)
1 Press [EDIT] during play.
2 Turn the jog dial to select
“DIVIDE?” and press it.
A 4 second segment of the track is
played repeatedly, beginning at the
point selected.
3 Turn the jog dial to adjust the point
you want to divide the track and
press it.
Adjustments can be made approxi-
mately 8 seconds (16 seconds if the
track is monaural or recorded with
LP2, 32 seconds if the track is record-
ed with LP4) either side of the original
point. (-128 to +127)
4 Press [EDIT].
COMBINE (Combining 2 tracks)
1 Press [EDIT] while playing the lat-
ter of the two tracks you want to
combine or while stopped.
2 Turn the jog dial to select “COM-
BINE?” and press it.
While playing, the last 8 seconds of
the former track and the first 8 sec-
onds of the latter track play repeated-
ly.
3 When performed while stopped
Turn the jog dial to select the two
tracks to combine.
4 Press [EDIT].