ProForm PFEX34310 - Manual (Page 8)

71
26
Jack
11. Plug the Power Supply (71) into the jack at the bot-
tom of the Rear Shield (26). Note: The Power
Supply may look different from the one shown.
IMPORTANT: When unplugging the Power
Supply, always unplug the Power Supply from
the recumbent cycle first, and then from the wall
outlet.
12. Make sure that all parts are properly tightened before you use the recumbent cycle. Place a mat
beneath the recumbent cycle to protect the floor. Note: After assembly is completed, extra hardware may be
left over.
8
40
41
Tab
19
11
7
9
10. Identify the Left Pedal (40), which is marked with an
“L” for identification. Using an adjustable wrench,
firmly tighten the Left Pedal
counterclockwise into
the left arm of the Crank (19). Firmly tighten the
Right Pedal (not shown)
clockwise into the right arm
of the Crank. Important: After using the recum-
bent cycle for one week, retighten the Pedals.
The Pedals must be kept properly tightened.
Adjust the Left Pedal Strap (41) to the desired posi-
tion and press the Pedal Strap onto the tab on the
Left Pedal (40). Adjust the Right Pedal Strap (not
shown) in the same way.
9. Pull the knob on the Seat Carriage (11), and slide
the Seat Carriage onto the Seat Rail (7). Move the
Seat Carriage to the desired position and release
the knob. Move the Seat Carriage forward or back-
ward slightly until it locks into place.
Attach the two Bumpers (62) and the Bumper Axle
(72) to the Seat Rail (7) with the M5 x 12mm Screws
(61) as shown. Press the Seat Rail Endcap (23) into
the end of the Seat Rail (7).
Tighten the four M8 x 20mm Button (31) Screws that
hold the four Seat Carriage Bushings (69) to the Seat
Carriage (11).
10
61
62
72
61
62
23
7
Knob
11
31
69