Philips DCB146 - Manual (Page 17)

English
17
FM Radio
Tuning to radio stations
1
Press SOURCE (or TUNER/DAB on the
remote control ) repeatedly until the desired
waveband (FM) is displayed.
2
Press briefly SCAN.
➜ The radio automatically tunes to a station
with sufficient reception. “Searching.... “ is
displayed during automatic tuning.
3
Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING 4
¢ (or 4 ¢ on the remote control)
briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 30 radio stations
in the memory.
Automatic programming
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be erased.
● Press and hold SCAN for more than two
seconds to activate programming.
➜ “FM Scanning...” is displayed during searching
and storing.
➜ All available stations are programmed.
Manual programming
1
Tune to your desired station (see Tuning to radio
stations).
2
Press briefly PROG on the remote control to
activate programming.
3
Press PRESET + + + + +/- - - - - (or 3 / 4 on the
remote control ) to allocate a number from 1 to
30 to this station.
4
Press and hold PROG to confirm the setting.
➜ The preset number and the frequency of the
preset station are shown.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESET + + + + +/- - - - - (or 3 / 4 on the
remote control ) until the desired preset station
is displayed.
DCB146_05_Eng 7/1/08, 12:02 17