ProForm PFHK99902 - Manual (Page 20)

20
How to Move the Incline Trainer
Before moving the incline trainer, change the grade of the incline trainer to the lowest level and unplug
the power cord.
1. Hold the handrails as shown and place one foot against
the walking belt.
2. Tilt the incline trainer back until it rolls freely on the wheels.
The help of a second person may be helpful when tipping
the trainer. Carefully move the trainer to the desired loca-
tion. Never move the trainer without tipping it back. To
reduce the risk of injury, use extreme caution while
moving the trainer. Do not attempt to move the trainer
over an uneven surface.
3. Place one foot on the walking belt, and carefully lower the
incline trainer until it is resting on the floor.
Wheels
Trouble-shooting
Most problems can be solved by following the steps below. Find the symptom that applies, and follow the
steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-
3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppres-
sor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor
must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation
of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps.
Important: The incline trainer is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the incline
trainer near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
d. Check the on/off switch located on the incline trainer
near the power cord. The switch must be in the on
position.
Tripped Reset
Tripped
c
Reset
On
Position
d