ProForm PFEL5055 - Manual (Page 4)

4
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires your own phillips screwdriver and rubber
mallet .
As you assemble the elliptical exerciser, refer to the drawings below to identify the small parts used in assembly.
The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 17.
The number following the parentheses is the quantity used in assembly. Note: Some small parts may have
been preassembled. If a part is not in the parts bag, check to see if it is preassembled.
M10 Split
Washer (73)–6
M4 x 16mm
Screw (94)–4
Bolt Set (65)–2
M10 Nylon
Locknut (89)–2
M8 Jam Nut
(81)–6
M8 x 44mm Button
Screw (84)–4
M10 x 55mm
Carriage Bolt (83)–2
M8 x 41mm Button
Bolt (80)–4
M10 x 90mm Carriage
Bolt (90)–2
M10 x 20mm Button
Screw (49)–6
M4 x 16mm
Round Head
Screw (69)–1
M10 Washer
(20)–2
M8 x 38mm Button
Bolt (85)–2
M4 x 19mm
Screw (91)–4
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 90mm Carriage
Bolts (90) and two M10 Nylon Locknuts (89).
1
8
89
1
90