Philips MBD3000 - Manual (Page 15)

16
4 Get started
Caution
Use of controls or adjustments or •
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
Prepare the remote control
1
Press and push the battery compartment
to slide it open (see “1” in the
illustration).
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Push and slide back the battery
compartment (see “3” in the illustration).
Note
If you are not going to use the remote control •
for a long time, remove the batteries.
Do not mix batteries (old and new or carbon
•
and alkaline, etc.).
Batteries contain chemical substances, so they
•
should be disposed of properly.
Connect power
Caution
Risk of product damage! Ensure that the •
power supply voltage corresponds to the
voltage printed on the back of the unit.
Before connecting the AC power cord, ensure
•
you have completed all other connections.
Note
The type plate is located on the bottom of the •
product.
1
Connect the AC power cable to:
this product. •
the wall socket. •
This product is ready to be set up •
for use.
EN