Philips CED750 - Manual (Page 2)

English
Connect wires: ISO connectors
1
Pull out the ISO connectors from the car
dashboard and connect them to the bigger
end of the supplied standard connector.
2
Connect the other end of supplied standard
connector to the unit.
If necessary, connect the following: •
Connector Connect to/with
1 Black cable Antenna
2 Yellow cable Video out 1
3 Yellow cable Video out 2
4 Yellow cable Camera in
5 Green/white
wire Parking
6 Black cable Bluetooth microphone
7 Blue cable Subwoofer
8 Red cable Front line out L
9 White cable Front line out R
0 Red cable Rear line out L
! white cable Rear line out R
Mount in the dashboard
Note
Check wire connection before you mount •
the unit into a car.
If preset radio stations are lost when the
•
ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to
the yellow ones.
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
If you disconnect the car battery in •
a car that has an on-board drive or
navigation computer, the computer may
lost its memory.
If the car battery is not disconnected,
•
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Ensure that car dashboard opening is within
these measurements:
Since the unit cannot be used if the •
dashboard opening’s slant angle is above
20 degrees: Ensure that the horizontal
slant of the car dashboard opening is
between 0 and 20 degrees
3
Remove the screws on the both side of the
unit.
4
Remove the mounting sleeve.
5
Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
6
Place the rubber cushion over the end of the
bolt.
7
Slide the unit into the dashboard until a click
sound is heard.
If the unit cannot fi t into the dashboard, •
remove the mounting bracket on the
both side of the unit and replace them
with the supplied short mounting
brackets.
8
Attach the trim plate.
9
Reconnect the negative terminal of the car
battery.
Turn on
1
Press the to turn on the unit.
The screen opens automatically.
»
The available OSD (On-Screen Display)
»
languages are displayed.
2
Touch a language to select.
The OSD language is changed to the
»
selected language immediately.
To adjust the screen tilt, press • TILT .
To close the screen, press • OPEN/CLOSE .
To adjust the brightness/contrast, press • / ,
then adjust 4 WAY NAVIGATION .
To turn off the system, press
• for 3 sec-
onds.
The screen closes automatically.
»
Set clock
1
Touch to display main menu.
2
Touch [Setting].
The setup menu is displayed.
»
3
Touch [General].
4
Touch the [Clock mode] repeatedly to
select:
[12hr] • : 12 hour mode
[ • 24hr] : 24 hour mode
5
Touch the hour digits, then touch or .
6
Touch the minute digits, then touch or .
7
If 12 hour mode is selected, touch or
to select AM or PM .
8
Touch to exit.
Tune to a radio station
1
Touch to display the main menu.
2
Touch [Radio].
Band and frequency information is
»
displayed.
3
Touch [Band] repeatedly to select:
FM band options: • FM1, FM2, FM3
AM band options: • AM1, AM2
4
Briefl y touch [Previous] or [Next] to tune
to a radio station by step.
Play discs
1
Insert the disc into the disc slot with label
side facing up.
Play starts automatically.
»
To remove the disc, press the
»
button.
When the disc is ejected, the unit switches
»
to the previous source, if connected. Other-
wise, the unit switches to [Radio] mode auto-
matically.
Insert USB or SD/MMC card
1
Open the USB/SD/MMC card cover.
2
Insert the USB device or SD/MMC card into
the USB socket or SD/MMC card slot.
Play starts automatically.
»
Pair the Bluetooth-enabled
devices
1
Turn on the Bluetooth function on the
device.
2
Setup the Bluetooth function on your device.
3
Select “CED750” in the pairing list.
4
Enter default password “0000”.
iI pairing succeeds.
»
[Connect] is displayed
on the panel.
Make a call
1
Pair the phone with the system.
2
Touch to return to main menu.
3
Touch [Bluetooth].
The Bluetooth menu is displayed.
»
4
Touch to dial.
Receive call
1
If there is incoming call, [Incoming call…]
fl ashes on the screen. Speak into the Blue-
tooth microphone.
2
When conversation ends, touch to
terminate the call.
3
Prin
tin g in C hin a
Prin
tin g in C hin a
4
© 2008 Koninklijke Philips Electronics N.V.
All rights reserved.
CED750 QSG_Eng.indd 2 CED750 QSG_Eng.indd 2 2008-12-12 16:05:30 2008-12-12 16:05:30