ProForm PFBE1416.0 - Manual (Page 6)

1.
Attach one side of the Center Base (2) to the
Base (1) with two M10 x 90mm Bolts (26), two
M10 Washers (24), and two M10 Nylon Locknuts
(23).
Make sure the warning decal is in the
position shown. Do not tighten the Nylon
Locknuts yet.
Repeat this step for the other side of the
Center Base (2).
Before beginning assembly, make sure you
understand the information in the box
above. Important: Some of the parts
described in the assembly steps may be
preassembled. 1
23
1
2
Decal
24
24
26
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the exercise rack, make sure all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
This manual is designed to ensure that the
exercise rack can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY
6