Patton electronic G.SHDSL.BIS CPE WITH FIXED SERIAL INTERFACES 3088A - Manual (Page 4)

4 Model 3088A Series Quick Start Guide
Figure 2. Model 3088A/CA front panel
2.3 Power up indication
Verify that the Power LED (see figure 2 ) illuminates and remains lit.
3.0 Connect the G.SHDSL port
1. Obtain single-twisted-pair cable with an RJ-45 plug connector at each end.
2. Plug one end of the cable into the RJ-45 socket (labelled DSL) on the OnSite CPE.
— If you are connecting to a DSL service, plug the other end of the cable into the RJ-45 wall
socket that provides your G.SHDSL service.
— If connecting to another OnSite, verify the other end of the cable is connected to the DSL port
on other OnSite and the DSL port is correctly configured.
3. When a DSL link is established, the front-panel DSL LED will turn on.
DSL
Terminal
TM / ERR
Power
Activity
Link