Conditions – Panasonic HYBRID IP-PBX KX-TDA200 User Manual
Page 221
1.24 Administrative Information Output Features
Feature Guide
221
Conditions
•
SMDR Format
The following SMDR format can be set through system programming in order to match the
paper size being used in the printer:
a)
Page Length: determines the number of lines per page (
b)
Skip Perforation: determines the number of lines to be skipped at the end of every
page (
•
The SMDR data is not deleted even if the PBX is reset.
•
If the PBX is reset during a conversation, the call will not be recorded on the SMDR.
•
The following calls are regarded as two separated calls in the SMDR:
•
The PBX waits for a preprogrammed time period (
Call Duration Count Starting Time for
LCOT [208]) between the end of dialling and start of the SMDR timer for outgoing trunk
calls. When the PBX has sent out all dialled digits to the telephone company and this timer
expires, the PBX starts counting the call. A display PT shows the elapsed time of the call.
The starting time and the total duration of the call are recorded on SMDR.
If the reverse signal detection has been set (
1.5.4.5 Reverse Circuit), the PBX will start
counting the call after detecting the reverse signal from the telephone company regardless
of the above timer.
•
Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS-
232C) port (
RS-232C Parameter—New Line Code [800], RS-232C Parameter—Baud
a)
New Line Code: Select the code for the PC or printer. If the PC or printer
automatically feeds lines with carriage return, select "
CR.
" If not, select "
CR+LF.
"
b)
Baud Rate: A baud rate code indicates the data transmission speed from the PBX to
the PC or printer.
c)
Word Length: A word length code indicates how many bits compose a character.
Secret dialling
Controls secret dialling. If enabled, the dialled number will be
shown as dots.
This setting is effective only when the modified number is
selected in ARS dial setting above. If the user-dialled number
is selected in ARS dial setting, the dialled number will be
shown as dots regardless of this setting.
Privacy dial
Enables or disables privacy dial. If enabled, the last four digits
of the dialled telephone number and any additional digits after
connection will be shown as "X". (e.g., 123-456-XXXX)
Date order
The date order is changeable: month/day/year, day/month/
year, year/month/day, year/day/month.
– Calls before and after the flash/recall/EFA signal is manually sent during a
conversation
– Trunk-to-trunk calls by Call Transfer, FWD or DISA (recording each as "incoming
call" and "outgoing call")
Item
Description