Paxar Monarch 9855 - Manual (Page 8)

4
A b o u t R F I D S u p p l i e s
RFID supplies are available in four-inch widths and a variety of lengths. See the
table below for the minimum feed lengths, recommended print and supply position
settings, and non-print zone. Printing over the RFID tag (or inlay) causes printing
irregularity, so we recommend the following print and supply position settings.
Refer to the RFID Setup Guide & Supply Chart for illustrations to determine which
type of RFID supplies you are using and basic printer configuration information.
Transponder
Type
Width x Min.
Feed Length Print
Position* Supply
Position* Non-Print
Zone**
Alien  Technology
Squiggle Class 1 (64-bit)
4x1 +40 -50
0.3”
trailing edge
Alien  Technology
Squiggle Class 1 (96-bit)
4x1 +40 -50
0.3”
trailing edge
Rafsec  UCODE (96-bit)
Only EU & EFTA
4x1 +70 -80
0.5”
trailing edge
Alien  Technology
M Class 1 (96-bit)
4x1.5
No special settings
required
none
Rafsec  Class 1 (96-bit)
4x2
No special settings
required
none
Impinj  ZumaRFID 0+
Propeller (96-bit)
Only USA & Canada
4x2
No special settings
required
none
Impinj  ZumaRFID 0+
Banjo (96-bit)
Only USA & Canada
4x6
No special settings
required
none
Matrics  Class 0+
(96-bit) Only USA & Canada
Contact
Paxar
For DEMO purposes none
TI-RFid 
Gen 2 (96-bit)
4x2
No special settings
required
none
Impinj  MonzaRFID
Gen 2 Propeller (96-bit)
Contact
Paxar
For DEMO purposes none
Impinj  MonzaRFID
Gen 2 Banjo (96-bit)
Contact
Paxar
For DEMO purposes none
Note: Matrics 0+ and Impinj Gen 2 protocols are only included for demo
purposes.