Patton electronic X.21 Interfaces - Manual (Page 6)

5
3.0 CONFIGURATION
The Model 2707 features configuration capability via hardware DIP
switches. This section describes all possible DIP switch configurations
of the Model 2707.
3.1 DIP SWITCH CONFIGURATION
The Model 2707 has one internal DIP switch that allow configuration for
a wide range of applications. The switch is accessed from the underside
of the 2707. Figure 1 shows the location of the DIP switch on the bottom
of the printed circuit board.
Figure 1. Underside of Model 2707, Showing Location of DIP Switches
The Model 2707 DIP switch can be configured as either “ON” or “OFF”.
Figure 2 shows the orientation of the DIP switch with respect to ON/OFF
positions.