Panasonic PV-V4525S - Manual (Page 14)

Multi-Brand Control Feature
The Remote Control can be set to control some TV functions.
After remote is set up, you can select VCR or TV for the desired function.
Press VCR or TV on the remote.
(Table below shows available unit buttons for each mode.)
• Not all functions listed may be controllable.
• In TV mode, it may be necessary to press ENTER after pressing NUMBER keys for channel selection.
➛ hold down TV button,
➛ enter code with NUMBER keys.
• Repeat setup after remote battery replacement.
• Remote will not control every TV made by the manufacturer listed. If you get no response, your particular
unit cannot be controlled. There are NO additional codes for the products listed. If your product is not listed,
then the remote is not compatible with that product.
Multi-Brand Control Setup
1
Find your TV Brand Code Number from those shown below.
2
Set up for TV control,
3
Confirm code entry,
➛ press POWER to turn your TV on or off.
• See table below for controllable functions in each mode.
Using Multi-Brand Control
Panasonic ................................... 01, 02
Quasar ......................................... 01, 02
RCA ................................................... 03
GE ...................................................... 03
Sharp ................................................. 06
TV Brand Code Numbers
Sony .................................................. 08
Toshiba .............................................. 09
Sanyo ................................................ 10
Fisher ................................................. 10
Hitachi ............................................... 12
• Some manufacturers use several codes for one brand. If the first code entered fails, try the next one listed.
• Some TV brands require you to turn on the power manually.
- 2 -
Notes
Notes
Important Notes
Notes
Mode
Unit
TV
VCR
TV
All VOL UP/DOWN
POWER, INPUT,
CH UP/DOWN, VOL UP/DOWN VCR/TV, PLAY, STOP, EJECT, SAP/Hi-Fi, DISPLAY,
FF, REW, PAUSE/SLOW, REC, SPEED, CM/ZERO,
RESET COUNTER, TAPE POSITION
VCR