Pioneer VSX-818V - Manual (Page 28)

Controls and displays 04
28
En
TUNER DISP*
Switches between named station presets
and radio frequencies (page 47).
CLASS*
Switches between the three banks
(classes) of radio station presets (page 47).
MPX*
Switches between stereo and mono
reception of FM broadcasts. If the signal is
weak then switching to mono will improve
the sound quality (page 46).
D.ACCESS*
After pressing, you can access a radio
station directly using the number buttons
(page 46).
MIDNIGHT
Switches to Midnight or Loudness
listening
(page 34).
ANALOG ATT
Attenuates (lowers) the level of an analog
input signal to prevent distortion.
DIMMER
Dims or brightens the display.
SLEEP
Press to change the amount of time before
the receiver switches into standby (
30 min
– 60 min – 90 min – Off ). You can check
the remaining sleep time at any time by
pressing
SLEEP once.
SIGNAL SEL
Use to select an input signal (page 36).
SR + (VSX-918V model only)
Switches the SR+ mode on/off (page 63).
iPod CTRL
Switches between the iPod controls and
the receiver controls (page 57).
DISC (ENTER)
Use to enter commands for TV or DTV, and
also use to select a disc in a multi-CD
player.
9 INFO
Use to bring up information screens on a
digital TV.
10 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
* ) in this section.
11 Remote control LED
Lights when a command is sent from the
remote control.
12 SOURCE
Press to turn on/off other components
connected to the receiver (see page 52 for
more on this).
13 RECEIVER
Switches the remote to control the receiver
(used to select the green commands above the
number buttons (
SETUP , etc)). Also use this
button to set up surround sound (page 37).
14 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the
TV CTRL button. Thus if you
only have one TV to hook up to this system
assign it to the
TV CTRL MULTI CONTROL
button. If you have two TVs, assign the main TV
to the
TV CTRL button (see page 51 for more on
this).
Use to turn on/off the power of the TV.
INPUT SELECT
Use to select the TV input signal.
TV CH +/–
Use to select channels.
TV VOL +/–
Use to adjust the volume on your TV.
VSX_918_818_KU.book 28 ページ ２００８年５月１５日 木曜日 午後６時４６分