Pioneer DVR-530H-S - Manual (Page 98)

The Initial Setup menu 13
98
En
Additional information about the TV system
settings
About the input line system
This recorder is compatible with PAL-N, 3.58 NTSC and
PAL-M TV systems. The Input Line System and Input
Colour System settings determine how the recorder
treats incoming video signals from an external input or
the built-in TV tuner.
Please note the following points when changing the
input line system:
• If, when the Input Line System setting is changed, the
screen goes blank (due to incompatibility with your
TV), you can switch back by pressing and holding the
front panel
STOP button then pressing OPEN/
CLOSE (also front panel) while the recorder is
stopped.
• When you switch the Input Line System setting the
Copy List is erased. If you switch the setting using the
STOP button and OPEN/CLOSE buttons as
described above, there is no confirmation, so please
use with care.
• You can’t mix recordings of different TV line systems
on the same disc.
• When you change this setting, the Input Colour
System setting also changes (see below).
About NTSC on PAL TV
Depending on the Input Line System setting and the
NTSC on PAL TV setting, the signal format output when
the recorder is stopped varies as shown in the table
below.
About the input colour system
The available options of the Input Colour System setting
depend on the Input Line System setting. The table below
shows the different options available.
Additional information about component
video output
If you switch the Component Video Out setting to
Progressive when using a TV that is not compatible
with progressive-scan video, you will not be able to see
anything displayed on your TV. If this happens, press and
hold the
STOP button on the front panel, then press
PLAY . This will set the recorder’s video output back to
Interlace.
Input Line System
NTSC on PAL
TV Output when
stopped
625 System Off PAL-N
On PAL-N
525 System Off NTSC
On PAL–M
Input Line System Built-in tuner External input
625 System PAL-N PAL-N
525 System Auto Auto
3.58 NTSC 3.58 NTSC
PAL–M PAL–M
Compatibility of this unit with progressive-scan TVs
Consumers should note that not all high-definition television sets
are fully compatible with this product and may cause artifacts to
be displayed in the picture. In case of 525 progressive scan
picture problems, it is recommended that the user switch the
connection to the ‘standard definition’ output (
Interlace ). If there
are questions regarding our TV set compatibility with this model,
please contact our customer service center.
This recorder is compatible with the following Pioneer displays
and monitors
Plasma display
• PDP-503HDG, PDP-433HDG, PDP-504HDG, PDP-434HDG,
DVR530HS_RDR.book 98 ページ ２００５年５月２６日 木曜日 午後３時１９分