Printronix 182043 - Manual (Page 3)

RFID Label Guide Specification
96 Bit Class 1 Squiggle Antenna
182043-000 Rev A Page 3 of 5
3.4. Perforations Between Labels
3.4.1. For SL5000 models – per user requirements except no perforations for Peel Mode.
3.4.2. For SLPA7000 models – no perforation between labels.
3.5. Roll Configurations
3.5.1. SL5000 models
3.5.1.1. Inside core diameter: 3 inches
3.5.1.2. Outside roll diameter: 8" maximum
3.5.1.3. Label wind direction – label side out with orientation per Figure 1.
3.5.2. SLPA7000 models
3.5.2.1. Inside core diameter: 3 inch core acceptable for label lengths less than 5"
with inlay lengths less than 2". For inlays lengths greater than 2" and/or
label lengths greater than 5" core diameter shall be 6".
3.5.2.2. Outside roll diameter: up to 12" maximum.
3.5.2.3. Label wind direction – label side out with orientation per Figure 1.
3.5.3. General
3.5.3.1. Roll to be wound with sufficient tension to prevent telescoping during
transit and handling.
3.5.3.2. Splices to use clear tape, should be angled and placed under the labels and
not between.
3.6. Inlay
3.6.1. Inlay shall incorporate the Alien 96 bit, Class 1, Squiggle inlay.
3.7. Tag Programming
3.7.1. Optional enhancement as a guideline for maximum production throughput, program
all good tags with a leading hex value of A5A5.
3.8. Label Construction
3.8.1. Inlay location with respect to label facestock outlined in Figure 1.
3.8.2. Nominal label facestock width with Squiggle inlay is 4.0". Maximum width of label
construction supported by printer is 4.5" edge to edge (4.1" is printable).
3.8.3. Minimum supported label length with Squiggle inlay is 2.0". Longer label lengths
per user requirements.
3.8.4. Inlay placement with respect to edge of liner is critical. It is acceptable to reduce the
width of exposed liner along the right side of the label – see Figure 1.
3.8.5. Gap Sensing
3.8.5.1. Nominal gap between labels for gap sensing is 0.125". Minimum gap
supported is 0.10".
3.8.5.2. 1.0" minimum x 0.125" timing marks on the liner under the gap.
3.8.6. Release Characteristics