Precor Strength-Training S3.45 - Manual (Page 17)

S3.45 Assembly and Maintenance Guide
page 17
1 2 3 4 5 6
8. Assemble Preacher Curl
Weight Stack
Before assembling the Weight Stacks, be certain the
S3.45 is positioned in its permanent location.
A. Place two Guide Rods (from Box 1) into the large
holes on the Preacher Curl side of the Main Base.
The Guide Rods will be unstable until you
complete step 5.
B. Place one Weight Cushion (from Box 1) on each
Guide Rod and allow it to slide down to the top of
the Main Base.
C. Apply one tube of lubricant to each Guide Rod.
Avoid getting lubricant on your clothing or on other
parts of the machine.
D. Add the five 15-lb weights, the ten 10-lb weights,
and the five 5-lb weights. Note the tab location for
weight stickers (you will attach the stickers later).
Hold your finger over the plastic bushing in each
weight to prevent the bushing from popping out.
CAUTION: The weights are heavy! Handle
the weights carefully so as not to drop them
or injure yourself. Pick up and place one weight
at a time on the Guide Rods. Have someone
hold the Guide Rods in place while you slide
the weights on the stack.
E. Place the Cap Plate on the Guide Rods with
the hole facing toward you. Allow it to slide onto
the Weight Stack.
F. Insert the retainer pins of the Side Bracket into the
Guide Rods. Attach the Side Bracket to the Top
Frame using
one 2¾-inch bolt
two washers
one locknut
Wrench tighten.
Step 8. Assemble Preacher Curl Weight Stack
Top Frame
1 - 2¾" bolt
2 - washers
1 - locknut
Guide Rods (2)
Rear Upright
Weight
Cushions (2)
D
B
A
F
E Cap Plate
5 - 5-lb Weights
10 - 10-lb Weights
5 - 15-lb Weights
D
Side Bracket
Retainer
Pins
C