Poulan C342B - Manual (Page 15)

15
DR ILL TW O 7/1 6" H OL ES AT LO CA TIO N SH OW N
DRILL TWO
7/16" HOLES
1) CUT OUT TEMPLATE.
2) ALIGN BOTTOM AND LEFT EDGE
OF TEMPLATE AND DRAWBAR.
3) TAPE IN POSITION.
4) MARK AND DRILL 7/16" HOLES
NOTE: DRILL SMALLER PILOT HOLES
PRIOR TO DRILLING 7/16" HOLES
5) PROCEED WITH STEP 1 OF
ASSEMBLY INSTRUCTIONS