Philips UCZZ01930AB - Manual (Page 37)

35 Telephone answering machine (TAM)
8.4 Play, Record, or Delete an
Outgoing Message
You can record a personalized message
to be played when the answering
machine picks up an incoming call.
The maximum length of an outgoing
message is 1 minute.
1
Press
m in idle mode, scroll n to
ANSW MACHINE and press
o.
2
PLAY is displayed. Scroll
n to
RECORD OGM and press
o.
3
ANSW.&RECORD is displayed.
Scroll
n to select
ANSW.&RECORD or
ANSWER ONLY and press
o.
4
PLAY is displayed. Scroll
n to
select PLAY, RECORD OGM, or
DELETE and press
o.
• If PLAY is selected, the current
outgoing message is played.
• If RECORD OGM is selected, a
beep sounds and the handset
starts automatically recording a
message.
• If DELETE is selected and a
personal outgoing message was
previously recorded, DELETE?
is displayed. Press
o to delete
the personal message and
replace it with the predefined
default message.
(If a personal outgoing message
was not previously recorded, an
error tone plays and the handset
goes back to the previous step.)
8.5 Set the answer mode
There are 2 answer modes available:
Answer Only and Answer & Record. By
default, the answer mode is Answer &
Record, which lets your caller leave a
message on the answering machine. This
can be changed to Answer Only mode,
which does not allow your caller to leave
any messages on the answering machine.
1
Press
m in idle mode, scroll n to
ANSW MACHINE and press
o.
2
PLAY is displayed. Scroll
n to
ANSWER MODE and press
o.
3
The current status is displayed.
Scroll
n to select
ANSW.&RECORD or
ANSWER ONLY and press
o.
• The answer mode is set.
• A validation tone is emitted and
the screen returns to previous
menu.
Depending on the answer mode you have
selected, the appropriate default
outgoing message is played once the
answering machine picks up an incoming
call. The language of the default outgoing
message depends on the country
selected in Welcome mode.
You can set the answering machine to
play a personalized outgoing message.
See “Play, Record, or Delete an Outgoing
Message” above.
Note
Note
Tip