Pioneer DVR-510H - Manual (Page 32)

Getting started 04
32
En
2 Elapsed chapter time
3 Total running time of chapter
4 Data transfer rate
Shows the current data rate being read from the disc.
5 Copy protected material (!) / PureCinema
indicator (#)
Shows ‘ ! ’ if the playback material is copy-once protected.
Shows ‘ # ’ if the current video is 24 fps, progressive scan.
Recording display
1 Current title number
2 Elapsed recording time
3 Timer recording start and stop times
Shows the start and stop times if the current recording is
a timer recording.
4 Remaining recording time available
Shows the amount of space left on the disc in the current
recording mode.
5 Recording mode
Shows the current recording mode ( FINE , SP , LP , etc.),
and the total recording time of the disc.
6 Broadcast program title
Note
• When using the simultaneous play and record
feature, the display shows information for playback
only.
• During real-time copy, the copy source playback
information is displayed.
• If Frame Search is On (see Frame Search on page 98),
the frame number is shown next to the elapsed time
display when the disc is paused.
• Transfer rate shows the amount of video and audio
information recorded on the disc. It is not an
indication of picture/audio quality.
• The Video mode disc displays become the same as a
DVD-Video disc once the disc is finalized.
• The total recording time figure shown in parenthesis
is calculated based on a 12cm/4.7GB disc at the
displayed record setting.
• Recording and playback times for TV recordings are
approximately 0.1% shorter than the actual time. This
is because of the slightly different frame rates of TV
broadcasts versus DVD.
• Copy Once or Can’t Record messages may appear
in the stop or recording displays. These indicate that
the broadcast TV program contains copy control
information.
ì Rec
DVD-R Video
FINE (1h00m/DVD) Rem. 0h35m
9:00 PM – 10:00 PM
3 0. 00. 15
EVENING NEWS
Copy Once
Stereo
WNBC
6 5
1 2 3 4
DVR-03_HDD_KU.book 32 ページ ２００３年８月７日 木曜日 午前１０時４０分