Philips PT-LB10VU - Manual (Page 3)

SmartPanel Projector Driver Application Note Panasonic PT-LB10VU
© 2005 SP Controls Inc. 601 Minnesota Suite 115, San Francisco, CA 94107 [email protected]
The hidden functions available for the Panasonic with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
AV MUTE
DIGITAL ZOOM UP
DIGITAL ZOOM DOWN
FREEZE
SHUTTER
FUNC1
AUTO SETUP
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the SmartPanel. The Configuration Utility can
be used to customize these settings your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method RS-232 Polling (see note 1)
Control Wiring Option RS 232 and R Emitter (see note 2)
Both RS-232 and the IR Emitter must be wired to control the Panasonic. Wired Remote is not an option
as the PT-LB10VU does not have a wired remote input.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the SmartPanel Configuration and Installation
Manual
Lockout Timer 94 seconds (see note 3)
Inactivity Shutdown Disabled
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A 1B 3A 3B 2A 2B 4A 4B 6A 6B 5A 5B 7A 7B
SELECTION
(EXT. SWITCHER CTRL)
4 3 2 1
500mA MAX. CURRENT