Panasonic DLP PT-DW6300 - Manual (Page 19)

POSITION menu
E
NGLISH - 19
Settings
J Menu items displaying pattern depends on signals
You can control the digital zoom scale vertically and
horizontally, and digital zoom area. See “SCREEN SETTING”
on page 25.
Zooming range: 50% to 999%
Q When ASPECT setting is DEFAULT
You can change the zoom area in the setting of
SCREEN FORMAT in SCREEN SETTING.
Press I H to change the zoom scale of VERTICAL and
HORIZON.
Q When ASPECT setting is THROUGH
Digital zoom is not available.
Q When ASPECT setting is others
Zoom area is the setting of SCREEN FORMAT in
SCREEN SETTING.
Press I H to change the zoom scale of VERTICAL and
HORIZON.
If you have interference patterns of the projected image, which
is sometimes referred to as moire or noise, you can fine adjust
the timing of the clock. (Signals from RGB 1 IN/RGB 2 IN only)
(PT-DZ6710E only)
You can project on to specially shaped screens, such as
distortional and cylindrical shaped screens, using unique
image processing system. Press I H to cycle through the
options.
Signals from RGB 1 IN/RGB 2 IN/DVI-D IN and SDI (PT-DZ6710E only)
DEFAULT H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H DEFAULT
Signals from S-VIDEO IN
VID AUTO H S1 AUTO H VID AUTO(PRI.) H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H VID AUTO
Signals from other terminals
VID AUTO H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H VID AUTO
NOTE:
• If you project an image with an unmatched aspect ratio, the image may distort or some portions may be cropped. Select an aspect ratio
which preserves the intention of the image creator.
• The order of ASPECT types is defined not only by the input method but also by the input signals.
• If you project a copyrighted image enlarged or distorted by using ASPECT function in commercial use in a public place, such as a
restaurant or hotel, you might infringe on the copyright of the creator which is protected by copyright law.
• Selectable aspect ratio options vary according to input signals.
ZOOM
INTERNAL
Zoom area is the factory default setting
of SCREEN FORMAT in SCREEN
SETTING.
FULL
Zoom area is the setting of SCREEN
FORMAT in SCREEN SETTING.
CLOCK PHASE
NOTE:
• With PT-DW6300E and PT-D6000E, if the projecting signal’s
dot clock frequency is higher than 150 MHz, the adjustment
may not make a difference.
GEOMETRY
OFF Deactive
KEYSTONE
Adjusts projected image when
distorted to a trapezoid.
CURVED
Adjusts projected image when
distorted to a curved surface.
PC
For performing geometry correction
from a connected computer.
NOTE:
• GEOMETRY adjustment should be carried out by a person
who is familiar with the projector or by a service person
because a high level of skill is required to make successful
adjustment.