Polycom KIRK KWS6000 - Manual (Page 49)

Installing KIRK Codec Module
5–3
Installing the KIRK Codec Module
This section describes how to install the Codec Module in a media resource.
How to install the Codec Module
1
Power off the media resource.
2
Remove the cover of the media resource carefully:
— Place the media resource face down on a desk.
— Apply sufficient pressure to the tabs located at each of the four corners
of the unit while gently lifting the cover from the chassis.
— Once separated, set the front cover aside in a safe location.
3
Snap the two support posts into the printed circuit board of the media
resource.
4 Carefully insert the Codec Module into the Codec Module connector and
the two support posts on the printed circuit board.
Figure 5-2 Installing Codec Module on Pinted Circuit Board
5
Replace the cover by aligning the tabs with the proper positions and
gently press the cover onto the chassis until the tabs lock into place.
6
Connect the LAN cable to the media resource.
7
Power up the media resource.
Note Installation must be performed by authorized personal only and must be
performed at an approved ESD workstation.