Philips HTS3569 - Manual (Page 21)

English
EN 21
Get
st
ar
ted
Change speakers settings
Ideally the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position in order to
obtain the best possible surround sound.
1
Press DISC.
2
Press OPTIONS.
3
Press V to select [ Audio Setup ] in
the menu, then press B.
Audio Setup
Speakers Volume
Speakers Delay
HDMI Audio
CD Upsampling
Audio Sync
You cannot access speaker setup
options if this Home Theatre unit is not
in a complete stop mode. In such case,
press x twice.
To adjust the speakers volume level
4
Select [ Speakers Volume ] in the menu,
then press B.
Speakers Level Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
0dB
0dB
0dB
0dB
0dB
0dB
•
5
Press b B to adjust the volume level, then
press OK.
The test tone is emitted from the
speaker which you are adjusting.
Repeat the above setting for other
speakers until all the speakers output
level sounds equally balance.
To set the output delay time (centre and rear
speakers only)
6
Select [ Speakers Delay ] in the menu,
then press B.
Speakers Distance Setup
Center
Rear Left
Rear Right
0ms
0ms
0ms
7
Press b B to set the delay time, then
press OK.
Repeat the above setting for other
speakers until the sound output from
different speakers reach the listening
position at the same time.
Tips
Set longer delay time if the centre or rear speakers
are closer to the listening position than the front
speakers.
1ms setting for every 30cm distance between the
speaker and the listening position. •
•
8
To exit the menu, press OPTIONS.
•
•
1_hts3565-69_98_eng5_Final808.in21 21 1_hts3565-69_98_eng5_Final808.in21 21 2008-02-19 3:42:06 PM 2008-02-19 3:42:06 PM