ProForm PFBE1516.0 - Manual (Page 6)

6
ASSEMBLY
1.
Attach the Support (5) to the Base (1) with an
M10 x 55mm Button Screw (50) and two M10 x
80mm Button Screws (59).
Orient the Base Foot (22) with the grooves in the
position shown. Attach the Base Foot to the Base
(1) with an M4 x 12mm Self-tapping Screw (61).
1
50
5
1
59
59
Grooves
22
61
Before beginning assembly, make sure that
you have read and understand the informa-
tion in the box above. See the PART IDENTI-
FICATION CHART for help identifying small
parts.
To hire an authorized service technician to
assemble the weight bench, call toll-free
1-800-445-2480.
Before beginning assembly, carefully read the
following information and instructions:
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Assembly requires two persons.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
In addition to the included grease, assembly
may require the following tools (not included):
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. However, the weight
bench has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.