Psion Teklogix PrintAbout MP2000 - Manual (Page 9)

Getting Started
Printer Features
Before preparing your new PrintAbout for use, please refer to Figure 1 and familiarize yourself with the
locations of the various features of the printer.
Paper Door
Tear Bar Release Lever
Figure 1 - Printer Features
Battery Installation and Charging
The battery for your PrintAbout printer is shipped in an “uncharged” state. The battery must be charged using
the following instructions prior to using the printer for the first time. Maximum battery capacity is not reached
until after completing a minimum of three complete charge and discharge cycles.
Please refer to Figure 2. Install the battery by first placing the end of the battery where the battery contacts are
located into the printer, and then press down on the end where the release lever is located until the lever “snaps”
into place.
Paper Door
Battery
Right Side
Of Printer
Control Panel
Universal Port Cover
Carrying Strap
Power Connector
3