Panasonic Blu-ray DiscTM Home Theater Sound System SC-BTT490 - Manual (Page 48)

48
VQT3X49
F99
¾ The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
HDMI ONLY
¾ Some BD-Video discs can only be output with
HDMI.
NET
¾ While connecting to a network.
No PLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. ( > 39)
No READ
¾ The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
¾ The unit is carrying out an internal process.
This is not a malfunction. You cannot operate
the unit while “PLEASE WAIT” is displayed.
REMOVE
¾ The USB device is drawing too much power.
Remove the USB device.
SET  (“  ” stands for a number.)
¾ The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and
the indicated number
button at the same time for
more than 5 seconds.
U59
¾ The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
H  or F
(“  ” stands for a number.)
¾ Check and correct the speaker cable
connections.
¾ There is something unusual.
¾ Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2 Press [ Í/I] to turn the power on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
IPOD OVER CURRENT ERROR
¾ The iPod/iPhone is drawing too much power.
Remove the iPod/iPhone, and turn the unit off
and on again.
START
¾ The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD /
(“  ” stands for a number.)
¾ The firmware is being updated.
Please do not turn off the unit.
FINISH
¾ The firmware update is complete.
NOT CONDITIONAL
¾ The requested operation cannot be
conducted.
SET OK
¾ The stations are set, and the radio tunes to
the last preset station.
ERROR
¾ Automatic presetting is unsuccessful. Preset
the stations manually.
TUNED/STEREO
¾ Stereo broadcasting or stereo sound is
selected.
TUNED
¾ Monaural broadcasting or monaural sound is
selected.
On the unit’s display
SC-BTT490P_eng.book 48 ページ ２０１２年２月２２日 水曜日 午前９時１分