Philips MX975D - Manual (Page 15)

15
English
SUBWOOFER (MX 975D only)
1 STANDBY-ON y ............Switches the subwoofer on and
to standby.
2 ..........................................Status light.
3 CUT OFF FREQUENCY...Adjusts the frequency range
reproduced by the subwoofer.
4 SUBWOOFER LEVEL CONTROL
Adjusts the volume of the
subwoofer.
5 PHASE SELECTOR.........Selects the best bass
reproduction.
6 SUBWOOFER IN ............Connect to SUBWOOFER
PRE-OUT at the receiver.
7 SOURCE SELECTOR ......Selects the used signal input.
Keep at the SUBWOOFER IN
position if the receiver is
connected as described below.
8 AC MAINS ......................After all other connections
have been made, connect the
power cord to AC MAINS and to
the power outlet.
9 SPEAKER OUT ...............Not used with the receiver
supplied.
0 SPEAKER IN ...................Not used with the receiver
supplied.
The type plate is located on the rear of the subwoofer.
1 Use the cinch cable supplied to connect SUBWOOFER IN to
SUBWOOFER PRE-OUT at the receiver.
2 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
not, consult your dealer or service organization.
3 Connect the power cable to the power outlet. This switches
on the power supply. Do not connect the subwoofer to the
outlets of the receiver.
Note: To disconnect completely the subwoofer from the
power, remove the power plug from the power outlet.
The subwoofer must be adjusted to your listening
environment and to your speaker setup. This only needs to be
done once.
1 Press y to switch on the subwoofer.
y The status light turns green.
2 Play one of your favorite tracks at a normal listening level.
3 Turn SUBWOOFER LEVEL CONTROL to adjust the volume of
the subwoofer.
4 Select the reproduced frequency range by turning
CUT OFF FREQUENCY. The higher the cut off frequency is
set, the stronger the bass reproduction will be.
Note: The subwoofer reproduces the range between 35 Hz
and the frequency selected with CUT OFF FREQUENCY.
5 You may switch PHASE SELECTOR from 0° to 180°. Select
the setting that provides the sound that produces the bass
effect.
6 Press y to switch the subwoofer to standby.
y The status light turns red.
1 Press y to switch on the subwoofer.
y The status light turns green.
2 If the sound reproduction is noisy, reduce the volume of the
subwoofer.
3 Press y to switch the subwoofer to standby.
y The status light turns red.
Operation
Adjustment
Connections
Connectors
Controls
SPEAKER
OUT
IN
+
+
+
+
-
-
-
-
L L
R R L L
R R
AC MAINS ~
SOURC E SELECTOR SPEAKER IN / W IRELES S SUBWOOFER I N
SUBWOOFER IN PHASE SE LECTOR
0 ° 180 °
CUT OFF FREQUENC
Y
60 H z 150 Hz SU BW OOF ER LE VEL CONTROL
STANDBY - ON
MIN
MAX
HIGH POWER SUBWOOF ER
1
2
3
4
5
6
7
8
9
0